Prev
006 6 End caps laying in aluminum rail track...I am not sure where the rust came from
Next
Prev
009 9 After drilling out the remaining rivet washers, I pulled the rail free and you can see the rivet shaft and the fiberglass fluff in the joint. I sanded this fluff off after all rivet shafts were removed
008 8 The rivets toward the bow seemed to hold up better because water in the rail tended to move aft
007 7 More rivet washers in the aluminum rail
006 6 End caps laying in aluminum rail track...I am not sure where the rust came from
005 5 When the rubber insert was pulled, it had rivet washer caps laying in it
004 4 Starboard side bow...rubber insert has slipped back from end cap
003 3 Starboard side by cleat
Next
T

006 6 End caps laying in aluminum rail track...I am not sure where the rust came from

006 6
End caps laying in aluminum rail track...I am not sure where the rust came from
Click to expand...
There are no comments to display.

Media information

Category
Rub Rail Project
Album
001 1 Starboard side separation looking forward
Added by
Tad and Toby Jackson
Date added
View count
1
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top