Prev
010 10 The gap between the top and bottom halves of the boat was consistently about 1/8"
Next
Prev
013 13 Lump of 5200 after I tapped them with a hammer and piece of 5/8" thin wall pipe. Made a pretty good plug
012 12 The end cap was fairly corroded. A little elbow grease and sanding sponge brought it back pretty well
011 11 More rivet shafts to be removed
010 10 The gap between the top and bottom halves of the boat was consistently about 1/8"
009 9 After drilling out the remaining rivet washers, I pulled the rail free and you can see the rivet shaft and the fiberglass fluff in the joint. I sanded this fluff off after all rivet shafts were removed
008 8 The rivets toward the bow seemed to hold up better because water in the rail tended to move aft
007 7 More rivet washers in the aluminum rail
Next
T

010 10 The gap between the top and bottom halves of the boat was consistently about 1/8"

010 10
The gap between the top and bottom halves of the boat was consistently about 1/8"
Click to expand...
There are no comments to display.

Media information

Category
Rub Rail Project
Album
001 1 Starboard side separation looking forward
Added by
Tad and Toby Jackson
Date added
View count
4
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top