Prev
03 Contact Stik glue sheets are very thin and transparent. It adheres very well to the surface.
Next
Prev
06 Berth Cushion in place. Please note we cut the HyperVent 6 inches in circumferance larger than the Berth cushion to allow the Hypervent to extend up the sides. IMPORTANT UPDATE JULY 2012. We had to cut the excess hypervent material to just fit the berth cushion's dimensions after several restless nights sleeping. We found that the original configuration caused the berth cushion to curl up slightly along the sides, forcing us to sleep in the middle. The manufacturer's instructions were right! We now sleep soundly, with no condensation underneath the cushion.
05 Center cushion holds the HyperVent pad in place
04 Completed installation. Our HyperVent pad is taped and secured by the DAP Contact Stik, and extends up the sides of the hull wall by 6 inches
03 Contact Stik glue sheets are very thin and transparent. It adheres very well to the surface.
02 Pattern of Contact Stik sheets placed on HyperVent membrane. I then peeled off the top layer to expose the Contact Stick glue strip, and then laid down the overlapping flap on the other piece to join the two pieces together. 9/26/12 update: it's been a full season and the tape is holding fast!
01 DAP Contact Stik -- thin sheets of double-sided glue sheets
00 Hypervent cross section and flap
Next
C

03 Contact Stik glue sheets are very thin and transparent. It adheres very well to the surface.

  • Media owner C-Nile
  • Date added
03 Contact Stik glue sheets are very thin and transparent. It adheres very well to the surface.
Click to expand...
There are no comments to display.

Media information

Category
HyperVent Installation in Marinaut 215 Berth, and Type of Glue Used
Album
00 Hypervent cross section and flap
Added by
C-Nile
Date added
View count
5
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top