Prev
14. Can you see inside the Dremeled out hole? Past the 3/8" hole in the outside layer of fiberglass, you should be able to see how the inside of the hole is larger in order to hold more epoxy and seperate the fastener in epoxy from the core.
Next
Prev
2. Showing adjustaqble RPM. at the back, and a variety of accessories for cutting and sanding in tight locations. www.dremel.com
1. This "DREMEL" MULTI-MAX was very good at helping with the job. When using the 1-3/16" Flexable Scraper Blade Cat. No. MM610, it cut through old caulking like butter. I was careful and made no noticable scrapes in the gel coat. A little wipping up with a rag and some Lacquer Thinner and the gel coat was clean.
Transom Fastener Improvements (17)
14. Can you see inside the Dremeled out hole? Past the 3/8" hole in the outside layer of fiberglass, you should be able to see how the inside of the hole is larger in order to hold more epoxy and seperate the fastener in epoxy from the core.
13. Transom Fastener Improvements
12. Transom Fastener Improvements
11. Transom Fastener Improvements
Next
R

14. Can you see inside the Dremeled out hole? Past the 3/8" hole in the outside layer of fiberglass, you should be able to see how the inside of the hole is larger in order to hold more epoxy and seperate the fastener in epoxy from the core.

14. Can you see inside the Dremeled out hole? Past the 3/8" hole in the outside layer of fiberglass, you should be able to see how the inside of the hole is larger in order to hold more epoxy and seperate the fastener in epoxy from the core.
Click to expand...
There are no comments to display.

Media information

Category
Fastener Improvements 2009 23 Venture "Pacific Wanderer"
Album
1. Cockpit Floor Fastener Improvements. All original No. 10 screws and hardware still in place before starting improvements.
Added by
ross_ballard
Date added
View count
0
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top