A hole was drilled thru the "L" bracket and a bolt with knob is used to hold things in place. This single bolt is really just a pin and is held in place by Velcro. It keeps everything in place very snug when the table is up folded down as pictured.

Open storage under foot. I used porch paint and a clear coat on the raised floor decking. It's held up good after 2 seasons.

Note: The storage hatch cover Hinge was moved to the left so the box can slide back and a tab was added inside the hatch to support the lid. Also, I used some left over latch parts on the floor, this keeps the table leg from sliding backward. Also added a pad on the leg for the table to rest against.

A hole was drilled thru the "L" bracket and a bolt with knob is used to hold things in place. This single bolt is really just a pin and is held in place by Velcro. It keeps everything in place very snug when the table is up folded down as pictured.

Sliding seat in new position.

A lumbar pillow is nice to use here. We often sit on a PFD cushion for a better look-out/view. Not pictured here, I added a snap under the table and a small strap snaps into it and then snaps onto the existing cushion snap. This hold the back-rest cushion in place.

I started to build a drawer but did not like the loss of storage space. There is a lot of space in here. The base panel sits inside on little feet that raises it up above the
T-Track.

Handle for moving the box. It slides very easy on the plastic rails.

These are Sea Dog slide bolts that hold the box in position. 2 holes drilled in floor.

M

A hole was drilled thru the "L" bracket and a bolt with knob is used to hold things in place. This single bolt is really just a pin and is held in place by Velcro. It keeps everything in place very snug when the table is up folded down as pictured.

Montana Kev
Jun 25, 2011

There are no comments to display.

Top