Prev
after filling the crack and all the holes with thickened epoxy I put the rail back up and redrilled only the holes that I was putting a bolt thru
Next
Prev
I cut little squares from a roll of butyl tape to put where the fasteners go. I was originally going to roll the butyl tape but I felt this would work better. I dont want any water trapped in the rub rail, and I thought that this would allow it to drain. I also am not going to caulk the top or bottom of the rain after its all tightened up.
I started drilling holes at the back of the boat and worked my way to the front. the back has the sharp bend, so I wanted to make sure that it fit good around the bend
after filling the crack and all the holes with thickened epoxy I put the rail back up and redrilled only the holes that I was putting a bolt thru
Next
C

after filling the crack and all the holes with thickened epoxy I put the rail back up and redrilled only the holes that I was putting a bolt thru

after filling the crack and all the holes with thickened epoxy I put the rail back up and redrilled only the holes that I was putting a bolt thru
Click to expand...
There are no comments to display.

Media information

Category
Rub rail repair
Album
a heat gun helps get it started
Added by
clayhubler
Date added
View count
0
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top