Cooler holder for rack. Used 2 36" x 1/4 brass threaded rodsfrom H.D. (each cut in half to make 4. Used 1/4 SS cap nuts on front 1/4 ss nylock nuts on back. Used 1/2" sced. 40 PVC as top seperator. Drilled a couple 7/8" holes in the bottom and used 18"x1/2 threaded PVC risers with twist on caps (spaced and located so they can be placed through any 2 rungs on the ladder/rack, so that cooler can be placed anywhere on rack to maximize boat balance and or rear view. I used 7/8" wood (just because I had it) 1/2" starboard would likely be more durable but this will last a long time. May need to notch for the spring latch so that it can fit far left.
- cemiii
- Dec 23, 2009
- 0
- 0
