Prev
another shot of the 3/8 round rod welded in to try and prevent cracks. We are trailering to Yellowstone and Grand Teton from Pa. in early August. so we shall see how well this works. It held up well 6600 miles no recracking.
Next
Prev
stainless steel bolt heads on the fender support show plate bolted in underneath step all the way thru and bolted to the trailers frame
fender support with brace installed
A closer picture of the new 1600PSI electric over hydraulic brake actuator with the Carlisle HBA Cam adapter which is recommended to make the controller think it's still controlling electric brakes rather than hydraulic brakes. Cam stands for Control Adapter Module
another shot of the 3/8 round rod welded in to try and prevent cracks. We are trailering to Yellowstone and Grand Teton from Pa. in early August. so we shall see how well this works. It held up well 6600 miles no recracking.
added 3/8 round stock to try and prevent future crack ups
Float -On trailer's extremely thin aluminum fender we climb into the boat using this fender and it's rear support
both front and rear radius areas cracked,see weld
Next
W

another shot of the 3/8 round rod welded in to try and prevent cracks. We are trailering to Yellowstone and Grand Teton from Pa. in early August. so we shall see how well this works. It held up well 6600 miles no recracking.

  • Media owner Will-C
  • Date added
another shot of the 3/8 round rod welded in to try and prevent cracks. We are trailering to Yellowstone and Grand Teton from Pa. in early August. so we shall see how well this works. It held up well 6600 miles no recracking.
Click to expand...
There are no comments to display.

Media information

Category
Trailer Mods
Album
P1000486 Some scrap 3 x 4" aluminum angle 1/2" stainless u-bolt 35 dollar stainless turnbuckle, short piece of chain, and a shackle.
Added by
Will-C
Date added
View count
2
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top