Another view of the washer and seat back position. As needed a 2nd washer can be used on the seat back frame to position it even farther forward. I have made spares for this purpose that I just set in place as desired. In this photo you can also see the new support frame which raised the seat an additional 1 inch - giving better view when piloting.

Always ready to deploy fender for use in a fishing rod holder. Thanks to Will-C for the idea, based on a photo in his album.

No foam had to be removed, just smoothed a bit.

New 12x24" storage hatch in v-berth. Hatch cover made by T-H Marine.

Another view of the washer and seat back position. As needed a 2nd washer can be used on the seat back frame to position it even farther forward. I have made spares for this purpose that I just set in place as desired. In this photo you can also see the new support frame which raised the seat an additional 1 inch - giving better view when piloting.

1" washer folded in half and set on to seat frame. #4 screw used to secure it. Seatback will now be in a more upright position offering better support.

Generator in place and ready to run. Security wire or chain is run through rod holder and locked so it cannot be pulled out.

Platform set on, with the brass screws (tops removed)used to hold the platform in place. All 3 pieces are completely separate which allows for easy setup, removal, and storage. Nothing is attached to or screwed into the boat.

M

Another view of the washer and seat back position. As needed a 2nd washer can be used on the seat back frame to position it even farther forward. I have made spares for this purpose that I just set in place as desired. In this photo you can also see the new support frame which raised the seat an additional 1 inch - giving better view when piloting.

maryvmcclain
Feb 16, 2013

There are no comments to display.

Top