Prev
Apply a little grease to the hub or seal before sliding onto hub.
Next
Prev
This really works, fill-er-up. Fill the oil cap completely full with gear oil than twist it on. Even if you don?t catch the thread perfectly and have to back twist you probable will not lose more than a drop or two. Believe me this is a lot easier than trying to fill the hub through the little hole in top. A full cap will top it off perfectly, its how they do it at the factory.
Tighten the wheel bold tells it?s good and snug, than back it off about 1/8th to 1/4th turn. Install lock ring and a new cotter pin.
Put things back together in reverse order.
Apply a little grease to the hub or seal before sliding onto hub.
Make sure the hub is clean expecually where the seal makes contact.
Seal should be flush with the rim.
Us a block of wood and rubber mallet to gently tap the seal into place. Work around the edges with the mallet and frequently check to make sure it?s going in straight.
Next
B

Apply a little grease to the hub or seal before sliding onto hub.

  • Media owner breausaw
  • Date added
Apply a little grease to the hub or seal before sliding onto hub.
Click to expand...
There are no comments to display.

Media information

Category
Oil bath wheel bearing service.
Album
Make sure you have placed a jack stand on each axel. If your trailer is duel axel only remove one wheel at a time, this provides a higher level of safety.
Added by
breausaw
Date added
View count
2
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top