Prev
fuel polisher built on the Dr. Bob design. I used scraps of pressure treated lumber, a 12v fuel pump, an a fuel separator with clear bottom. Wired with 6 feet of quick conncect wire, inline on/off switch, and battery clips.
Next
Prev
Motor Sports Marine Restorations
I tried to send the fuel line down the fuel fill - no go; too sharp a bend. I then disconnected the fuel line to the tank selection valve and could pump gas from one tank and then the other, from one tank to the other.
12v fuel pump siphons the gas from the tank and pushes it through the 10 micron filter. Fuel pump is equipped with a 100 micron pre-filter.
fuel polisher built on the Dr. Bob design. I used scraps of pressure treated lumber, a 12v fuel pump, an a fuel separator with clear bottom. Wired with 6 feet of quick conncect wire, inline on/off switch, and battery clips.
Grandma showing Anthony the ropes
Hey Grandapa! Let's go fishin'
Grandson Anthony at the helm
Next
S

fuel polisher built on the Dr. Bob design. I used scraps of pressure treated lumber, a 12v fuel pump, an a fuel separator with clear bottom. Wired with 6 feet of quick conncect wire, inline on/off switch, and battery clips.

  • Media owner Swee Pea
  • Date added
fuel polisher built on the Dr. Bob design. I used scraps of pressure treated lumber, a 12v fuel pump, an a fuel separator with clear bottom. Wired with 6 feet of quick conncect wire, inline on/off switch, and battery clips.
Click to expand...
There are no comments to display.

Media information

Category
Swee Pea
Album
Not an original photo of Swee Pea, but her twin.
Added by
Swee Pea
Date added
View count
4
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top