Prev
Here I have applied some with an undercoating spray gun.
Next
Prev
I used my shop vac to blow warm air in. I left it on over night because I had sprayed so much material (about 3 gallons).
Time to cover up my new seat.
I am concentrating mostly on the V berth area for noise and condensation abatement. Two coats was enough so that I could no longer see the roving in the fiberglass layup. I put on four coats in the V berth and two in the cabin.
Here I have applied some with an undercoating spray gun.
This is my home-brew insulating paint. It is some leftover latex water proofing paint used on concrete block prior to applying a stucco finish. It dries thick and to a consistency about like a pencil eraser. I'm adding micro balloons to it (the secret ingredient).
It is then taped over the fittings. The foam expands, insulating the fittings and keeping them from dripping condensation. This is the bow roller and you can just see the thru deck block before the hawse pipe was installed.
Here is how the through hull metal fasteners were insulated. Foam was shot into a plastic jar lid.
Next
M

Here I have applied some with an undercoating spray gun.

Here I have applied some with an undercoating spray gun.
Click to expand...
There are no comments to display.

Media information

Category
Insulating Coating
Album
This is my home-brew insulating paint. It is some leftover latex water proofing paint used on concrete block prior to applying a stucco finish. It dries thick and to a consistency about like a pencil eraser. I'm adding micro balloons to it (the secret ingredient).
Added by
Marco Flamingo
Date added
View count
4
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top