Home made from scraps of the Starboard. This might just work, but am not going to fasten them on quite yet without approval from the skipper..

Lori said, our boat has no name on it... Every boat needs a name on it... Soooo, it now has a name on it.

Lori said, there is no place to just put something on this boat without setting it on the table, counter, dash, or seat... So I installed a 6 x 60 inch Port shelf trimmed in teak above the table for just stuff,,,and it already is filling up with just stuff..

Hinges made from starboard are made so they hold the lid open without a tie back

$Finished the box and installed it to make sure it still fit after assembly, and the thing actually sets in the opening pretty good. Not real professional quality built and the color will never match , but it should work for what I am using it for just the same. Whacked out a couple scrap pieces into a hinge to see what they would look like for pivoting it forward should I ever need the engine to be tilted completely up. Not sure if I will just make them or buy a couple Perks or something like them. They are easy to make and will probably pass with a push so might go ahead and cut a couple out of the left over scraps. That way if the wife gives them one of her \"I\'m not sure about these\" looks, I can just toss them and haven\'t lost anything but time.$

The two side pieces that have the screws left in them cannot be welded. 8x32 screws tapped into the end plates work great for holding them in place. They keep the rode from slipping down between the drum and sides in case you overfill the drum. Holds 300 ft. of 3/8 rode and chain.

Home made from scraps of the Starboard. This might just work, but am not going to fasten them on quite yet without approval from the skipper..

Sea-C
Aug 25, 2014

There are no comments to display.

Home made from scraps of the Starboard. This might just work, but am not going to fasten them on quite yet without approval from the skipper..

Media information

Share this media