Prev
I put two vents in with the louvers facing up for heat removal. This one is facing forward at the co-pilot seat.
Next
Prev
The two vents allow heat to escape, there is sufficient bilge venting down low for cool replacement air. This vent in under the dinette table.
I put two vents in with the louvers facing up for heat removal. This one is facing forward at the co-pilot seat.
Ready for action!
Here is the cooler installed. AC and DC lines are on a long, suspended loop behind. I had to remove the lift handle from the front of the Engel to get it to fit snug.
Here is the finished drawer with trim. I used a barrel bolt to keep it latched. There is a detent in the pantry slide, but it is not very strong. I don\'t like the barrel bolt and will likely look for a better-looking alternative.
Here is the drawer painted and almost ready. As I was measuring things, there were a few extra inches on the side of the cooler - I couldn\'t let that go to waste! I made some shelves for storing cans alongside.
Here are the snap-in mating parts for the pantry slides. It makes removal really easy!
Next
R

I put two vents in with the louvers facing up for heat removal. This one is facing forward at the co-pilot seat.

  • Media owner Ray
  • Date added
I put two vents in with the louvers facing up for heat removal. This one is facing forward at the co-pilot seat.
Click to expand...
There are no comments to display.

Media information

Category
Engel cooler drawer
Album
This was the standard Norcold install under the copilot seat.
Added by
Ray
Date added
View count
4
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top