Prev
I used a small circular saw and a jig saw to cut the openings.
Next
Prev
The plywood box is a mockup of a Group 31 battery. I may put batteries in here.
I used a large chisel and a hammer to pry pieces out. The foam was dry until I got to the very bottom, next to the hull, where it was damp.
I used a hand saw to cut vertically around the hatch openings, then used a recipro saw to cut the interior mass of foam into sections for removal.
I used a small circular saw and a jig saw to cut the openings.
There was no "standing water", but the foam at the bottom, next to the hull, was damp enough that you could squeeze water out of it. It tasted yucky, but only very slightly salty.
My boat had no inspection hole and no obvious hole of any kind where foam could have been injected. I decided to drill an inspection hole to see what was in there.
Next
P

I used a small circular saw and a jig saw to cut the openings.

  • Media owner pcg
  • Date added
I used a small circular saw and a jig saw to cut the openings.
Click to expand...
There are no comments to display.

Media information

Category
Foam removal
Album
My boat had no inspection hole and no obvious hole of any kind where foam could have been injected. I decided to drill an inspection hole to see what was in there.
Added by
pcg
Date added
View count
2
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top