Prev
Moisture on plwywood both from screw holes and from around the lack of caulking
Next
Prev
initial photo after the \"flapper\" valve is taken off. There is gel coat smeared over the wood boring, and some voids.
Foreward part of hatch plywood, with spray of gel coat over the raw edge
Two trim screw holes where water was comming thru the deck from hatch lack of bedding
Moisture on plwywood both from screw holes and from around the lack of caulking
Note the dirt on the foreward lip, and no bedding on the frame.
Hole, filled with clear epoxy, where 2\" #12 screw went into either core or support for foreward deck--was damp, dryed, epoxied and screw reset with sealant. The joint between the cockpit floor and aft bulkhead is now sealed to prevent any further water intrusion.
Screw holes in boat hull core filled with epoxy, after being undercut, then fillet to Decaboard, with sanding boat bottom and then laminating biaxial between decaboard and the boat bottom--no more screws into the core.
Next
T

Moisture on plwywood both from screw holes and from around the lack of caulking

  • Media owner thataway
  • Date added
Moisture on plwywood both from screw holes and from around the lack of caulking
Click to expand...
There are no comments to display.

Media information

Category
Thataway
Album
In driveway
Added by
thataway
Date added
View count
2
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top