Prev
My boat had no inspection hole and no obvious hole of any kind where foam could have been injected. I decided to drill an inspection hole to see what was in there.
Prev
I used a hand saw to cut vertically around the hatch openings, then used a recipro saw to cut the interior mass of foam into sections for removal.
I used a small circular saw and a jig saw to cut the openings.
There was no "standing water", but the foam at the bottom, next to the hull, was damp enough that you could squeeze water out of it. It tasted yucky, but only very slightly salty.
My boat had no inspection hole and no obvious hole of any kind where foam could have been injected. I decided to drill an inspection hole to see what was in there.
Next
P

My boat had no inspection hole and no obvious hole of any kind where foam could have been injected. I decided to drill an inspection hole to see what was in there.

  • Media owner pcg
  • Date added
My boat had no inspection hole and no obvious hole of any kind where foam could have been injected. I decided to drill an inspection hole to see what was in there.
Click to expand...
There are no comments to display.

Media information

Category
Foam removal
Album
My boat had no inspection hole and no obvious hole of any kind where foam could have been injected. I decided to drill an inspection hole to see what was in there.
Added by
pcg
Date added
View count
4
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top