Prev
Princess butane drop-in stove, flat stainless lidded version (other version has wooden cutting board that sits on top).
Next
Prev
Making a set of "usable mock-up from scrap" cover boards for the sink and former-Wallas hole in the galley counter. Two sheets of scrap 1/8" ply epoxied together to make 1/4", then cut and cleats affixed to the bottom side to hold them in place, and then varnished. Turns out they make sort of handy "butler's trays" when used upside down at anchor.
Board made utilizing some scraps to fill the hole from the Wallas (removed and sold). Just some scrap 1/8" ply epoxied together to make 1/4", then cut out, some cleats stuck to the bottom side, and then varnished.
Princess butane drop-in stove, flat stainless lidded version (other version has wooden cutting board that sits on top).
Princess butane drop-in stove, flat stainless lidded version (other version has wooden cutting board that sits on top).
14 There are three contoured supports like this supporting it all
12 this is how it gets back to the place where it goes across to port
11 water line runs along hull side out of the way
Next
S

Princess butane drop-in stove, flat stainless lidded version (other version has wooden cutting board that sits on top).

  • Media owner Sunbeam
  • Date added
Princess butane drop-in stove, flat stainless lidded version (other version has wooden cutting board that sits on top).
Click to expand...
There are no comments to display.

Media information

Category
Galley area
Album
Sink cover board while varnishing. I made a similar one (sans hole) for the cutout where the Wallas used to be. It's surprisingly handy to be able to remove it to work on things (wiring etc.) under the galley, although I may eventually replace the whole galley counter and if so will likely make it a solid piece except for the sink cutout.
Added by
Sunbeam
Date added
View count
4
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top