Prev
Rear view this should never break Used a 10.5" square piece of multiply conveyor belt. It can be cut with a sharp razor knife. Use over sized drill bits for holes when drilling the belt material. 30k + plus miles this is our original license plate.
Next
Prev
New to us Yamaha Motor stop for trailering
replaced cable with chains reused snap hooks
Retaining cable fails in half hooking up in 11 degree weather. Coated cable looked to have had corrosion caused by road salt just past the crimp. Removed and replaced with chain
Rear view this should never break Used a 10.5" square piece of multiply conveyor belt. It can be cut with a sharp razor knife. Use over sized drill bits for holes when drilling the belt material. 30k + plus miles this is our original license plate.
stainless steel fishing wire rated #90 test with crimps crimpers
side view of finished project, note plastic backing plate in between the license plate and the conveyor belting
5/16 thick multiply conveyor belting, 90 # stainless stranded fishing wire with crimped ends for license plate retention
Next
W

Rear view this should never break Used a 10.5" square piece of multiply conveyor belt. It can be cut with a sharp razor knife. Use over sized drill bits for holes when drilling the belt material. 30k + plus miles this is our original license plate.

  • Media owner Will-C
  • Date added
Rear view this should never break Used a 10.5" square piece of multiply conveyor belt. It can be cut with a sharp razor knife. Use over sized drill bits for holes when drilling the belt material. 30k + plus miles this is our original license plate.
Click to expand...
There are no comments to display.

Media information

Category
Trailer Mods
Album
P1000486 Some scrap 3 x 4" aluminum angle 1/2" stainless u-bolt 35 dollar stainless turnbuckle, short piece of chain, and a shackle.
Added by
Will-C
Date added
View count
3
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top