Prev
Remaining wet area at back. It is located in the crotch of the angle you can see in the overview.
Next
Prev
Front view after removing the wet areas and cutting out the un-adhered area. Note the wide kerfs. These are what the water followed up. One on the right is filled with nearly 1/2 inch fiberglass.
This is in the bow. You cansee the balsa looks good, but it is not adhered to the bottom and moisture trickled out.
Near v-berth support on starboard side. Where dark lines are may (probably?) needs more cleaning out?
Remaining wet area at back. It is located in the crotch of the angle you can see in the overview.
View of what I\'ve removed so far. Just two really wet spots left to explore.
Showing mud and water trail again and crack of the outer tabbing.
Note the dried mud areas where nothing was stuck down. You can also see the feather crack of the tabbing at lower right of photo. I just pulled that off by hand.
Next
J

Remaining wet area at back. It is located in the crotch of the angle you can see in the overview.

  • Media owner Jackie
  • Date added
Remaining wet area at back. It is located in the crotch of the angle you can see in the overview.
Click to expand...
There are no comments to display.

Media information

Category
Balsa core rot. (Liquification)
Album
First cutout. It was clearly hollow under here.
Added by
Jackie
Date added
View count
2
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top