Prev
Spent most of the winter drying out the core with a heat gun shooting into the holes when I had spare time.
Next
Prev
Undercut around the hole to give the fiberglass resin something to hold onto.
Mounted the transponder base to the bottom of the boat with a thin bead of silicone to hold it in place, fiberglass resin will be poured around it.
Spent most of the winter drying out the core with a heat gun shooting into the holes when I had spare time.
Cut into the lower area where water collects for the bilge pump and drain plug area so no puddles will form around the transponder mounting.
Notice the three holes where the bilge pump was mounted. Another potential water leak into the balsa core.
Marking the spot where the transponder base will be mounted.
Next
C

Spent most of the winter drying out the core with a heat gun shooting into the holes when I had spare time.

Spent most of the winter drying out the core with a heat gun shooting into the holes when I had spare time.
Click to expand...
There are no comments to display.

Media information

Category
Shoot Through The Hull Transducer Installation
Album
4 inch hole saw to begin the installation. Wanted it mounted as far aft as possible.
Added by
CaptainJeff
Date added
View count
2
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top