Prev
This is in the bow. You cansee the balsa looks good, but it is not adhered to the bottom and moisture trickled out.
Next
Prev
The whole shot so far. It is huge, and tbh, my cheap pin meter shows high moisture all around. There is no dry!
View of rear. The dark area onright is wet so I still need to clear a bit more in that direction.
Front view after removing the wet areas and cutting out the un-adhered area. Note the wide kerfs. These are what the water followed up. One on the right is filled with nearly 1/2 inch fiberglass.
This is in the bow. You cansee the balsa looks good, but it is not adhered to the bottom and moisture trickled out.
Near v-berth support on starboard side. Where dark lines are may (probably?) needs more cleaning out?
Remaining wet area at back. It is located in the crotch of the angle you can see in the overview.
View of what I\'ve removed so far. Just two really wet spots left to explore.
Next
J

This is in the bow. You cansee the balsa looks good, but it is not adhered to the bottom and moisture trickled out.

  • Media owner Jackie
  • Date added
This is in the bow. You cansee the balsa looks good, but it is not adhered to the bottom and moisture trickled out.
Click to expand...
There are no comments to display.

Media information

Category
Balsa core rot. (Liquification)
Album
First cutout. It was clearly hollow under here.
Added by
Jackie
Date added
View count
5
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top