Prev
Time to cover up my new seat.
Next
Prev
Once dry, it gets sprayed with an off white paint that is fairly close to the gel coat color. The surface of the rubber paint would attract too much dirt. Notice the black conduit hanging down. Black wiring was strung all around the boat. I can fix that.
Even the roof of the cabin gets a layer.
I used my shop vac to blow warm air in. I left it on over night because I had sprayed so much material (about 3 gallons).
Time to cover up my new seat.
I am concentrating mostly on the V berth area for noise and condensation abatement. Two coats was enough so that I could no longer see the roving in the fiberglass layup. I put on four coats in the V berth and two in the cabin.
Here I have applied some with an undercoating spray gun.
This is my home-brew insulating paint. It is some leftover latex water proofing paint used on concrete block prior to applying a stucco finish. It dries thick and to a consistency about like a pencil eraser. I'm adding micro balloons to it (the secret ingredient).
Next
M

Time to cover up my new seat.

Time to cover up my new seat.
Click to expand...
There are no comments to display.

Media information

Category
Insulating Coating
Album
This is my home-brew insulating paint. It is some leftover latex water proofing paint used on concrete block prior to applying a stucco finish. It dries thick and to a consistency about like a pencil eraser. I'm adding micro balloons to it (the secret ingredient).
Added by
Marco Flamingo
Date added
View count
7
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top