Prev
Us a block of wood and rubber mallet to gently tap the seal into place. Work around the edges with the mallet and frequently check to make sure it?s going in straight.
Next
Prev
Apply a little grease to the hub or seal before sliding onto hub.
Make sure the hub is clean expecually where the seal makes contact.
Seal should be flush with the rim.
Us a block of wood and rubber mallet to gently tap the seal into place. Work around the edges with the mallet and frequently check to make sure it?s going in straight.
Put the new seal in place.
Make dang sure you replace the rear bearing before installing the rear seal, don?t ask me how I know.
Clean all parts with a good solvent, gasoline works but don?t light up a cigarette!!
Next
B

Us a block of wood and rubber mallet to gently tap the seal into place. Work around the edges with the mallet and frequently check to make sure it?s going in straight.

  • Media owner breausaw
  • Date added
Us a block of wood and rubber mallet to gently tap the seal into place. Work around the edges with the mallet and frequently check to make sure it?s going in straight.
Click to expand...
There are no comments to display.

Media information

Category
Oil bath wheel bearing service.
Album
Make sure you have placed a jack stand on each axel. If your trailer is duel axel only remove one wheel at a time, this provides a higher level of safety.
Added by
breausaw
Date added
View count
3
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top