Prev
Wallas 1300 Install - DSC06133 - 12V socket and table latch will also have to be moved.
Next
Prev
Wallas 1300 Install - DSC06142 Made an "L" shaped bracket and drilled it to match the Wallas hanger. Will allow mounting in a tight spot between the hull and the lowered table, with just enough clearance above for the intake/exhaust, and just enough below for the fuel and return lines.
Wallas 1300 Install - DSC06140
Wallas 1300 Install - DSC06139
Wallas 1300 Install - DSC06133 - 12V socket and table latch will also have to be moved.
Wallas 1300 Install - DSC06132 Checked and rechecked clearances. It will be tight. Checked with SCAN Marine who assured me mounting the heater like this would be fine.
Wallas 1300 Install - DSC06131
Wallas 1300 Install - DSC06130 View below the raised table. Shelving will be removed here, and the outboard edge of the forward seat cushion (shown on the right) will be trimmed by about 1/2 inch to allow the table to hang just slightly further away from the hull to make room for the heater.
Next
N

Wallas 1300 Install - DSC06133 - 12V socket and table latch will also have to be moved.

  • Media owner NORO LIM
  • Date added
Wallas 1300 Install - DSC06133 - 12V socket and table latch will also have to be moved.
Click to expand...
There are no comments to display.

Media information

Category
NORO LIM Wallas 1300 Heater Installation
Album
Wallas 1300 Install - - DSC06129 Aft seat, shelving, & table; Heater to go where the shelving narrows - next to, and just forward of the aft seat. Chose the Wallas 1300 model because it's the most compact, and because I already had a kerosene stove.
Added by
NORO LIM
Date added
View count
7
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top