Wallas 1300 Install - DSC06180. Intake/exhaust installed. The heater warms the cabin nicely, whichever way the seats and table are configured. The louvers on the vent can be turned to direct heat at the First Mate's feet, whichever seat she is in. Ducting could be added.
Next
Prev
Wallas 1300 Install - DSC06180. Intake/exhaust installed. The heater warms the cabin nicely, whichever way the seats and table are configured. The louvers on the vent can be turned to direct heat at the First Mate's feet, whichever seat she is in. Ducting could be added.
Wallas 1300 Install -DSC06175. Wires connected. (Note the extra right angle brace at the top of the hanger bracket. Just a suspenders and belt move to make sure the heater stays put.)
Wallas 1300 Install -DSC06174. New shelf support in place.
Wallas 1300 Install -DSC06171. New shelving support assembled with power line connectors mounted.
Wallas 1300 Install -DSC06165. Pieces cut for rebuilding the forward part of the shelving.
Wallas 1300 Install -DSC06163 - Protection against inadvertently bumping the switch on or off made from a small scrap of 1/2" starboard
Wallas 1300 Install -DSC06159 Remote switch is mounted on the side of the helm where it is easy to reach from the helm seat, First Mate's seat, or v-berth.
Next
N

Wallas 1300 Install - DSC06180. Intake/exhaust installed. The heater warms the cabin nicely, whichever way the seats and table are configured. The louvers on the vent can be turned to direct heat at the First Mate's feet, whichever seat she is in. Ducting could be added.

  • Media owner NORO LIM
  • Date added
Wallas 1300 Install - DSC06180. Intake/exhaust installed. The heater warms the cabin nicely, whichever way the seats and table are configured. The louvers on the vent can be turned to direct heat at the First Mate's feet, whichever seat she is in. Ducting could be added.
Click to expand...
T
'Also present are monitors for both battery systems, remote control for the Inverter/charger, a 110 V plug for induction stove burner, and remote reading temperature sensors for the refrigerator and freezer. water heater is right under the sink, so minimal wasted hot water.
 

Media information

Category
NORO LIM Wallas 1300 Heater Installation
Album
Wallas 1300 Install - - DSC06129 Aft seat, shelving, & table; Heater to go where the shelving narrows - next to, and just forward of the aft seat. Chose the Wallas 1300 model because it's the most compact, and because I already had a kerosene stove.
Added by
NORO LIM
Date added
View count
9
Comment count
1
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top