Prev
with a narrow transom like this horizontal braces using the engine mount holes and 8\" screws works real well.
Next
Prev
added ~3/8 shim close to the sides to add the gentle curve in my transom and allow for the outside piece of glass to go on flush 360degrees.
Again
The light 3/8\" shims allowed for the ~1/4\" outside glass and a light 1/8\" of epoxy and microfiber paste.
with a narrow transom like this horizontal braces using the engine mount holes and 8\" screws works real well.
Had some weird crap going on at the edges making me change my cut line several times... no biggie.
Same...
Didn\'t check the thickness of the existing glass until after I ground it down and felt that it wasn\'t just one or two layers of mat. It was already 3/16+, but because I already ground it and had 2 layers of 1208, 1 of mat and the PeelPly cut, I went ahead and applied...
Next
F

with a narrow transom like this horizontal braces using the engine mount holes and 8\" screws works real well.

with a narrow transom like this horizontal braces using the engine mount holes and 8\" screws works real well.
Click to expand...
There are no comments to display.

Media information

Category
FrankisCaptBobo
Album
Didn\'t check the thickness of the existing glass until after I ground it down and felt that it wasn\'t just one or two layers of mat. It was already 3/16+, but because I already ground it and had 2 layers of 1208, 1 of mat and the PeelPly cut, I went ahead and applied...
Added by
FrankisCaptBobo
Date added
View count
5
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top