Recent content by BBSva

The repair was made with West System epoxy. The epoxy was slightly thickened and then reinforced with bits of chopped strand matting cut up with scissors. The result is a gooey mix of epoxy with fiberglass in the mix. Basically a redneck chopper gun mix. I have used this before and it works...

The fuel lines on my boat have now been replaced. The fuel filter has been relocated to the transom. I also took some time to relocate and upgrade some of the electrical gear. The old charger and most of the 1980's looking Stranger Things set piece electrical equipment was replaced. Loads...

new fuel lines

old shelf

repaired shelf

new fuel filter location

lazarette clean up

new electric organization

Thanks again to all for the feedback. Agreed on flooded cells in the cabin. For now I am going to leave the batteries where they are under the spashwell. When these batteries need replaced I will look into AGM or Lithium options and perhaps move from the transom. My primary goal is to...

Thanks for the feedback. I suspected the current setup was subpar. The lack of terminal fuse blocks and general state of the wiring seems less than ideal. I may not have much powerboat experience but I have fully restored and rewired a fiberglass RV using mostly Blue Sea components...

Hello all. I have a new to me 2006 C-Dory 22 Cruiser with a 2006 Honda outboard. This is the first power boat that I have owned, so a few of the components and systems are a bit outside of my knowledge level. The initial questions that I have are related to fuel line and electrical routing...

Looking forward to seeing how you fix this one up.