Recent content by CC Rider
-
CC Rider V Berth Mods
- CC Rider
- Album
- Comments: 0
-
20260602_182710.jpg
Starboard hatch open- CC Rider
- Media item
- Comments: 0
- Album: CC Rider V Berth Mods
-
-
-
20260602_182809.jpg
Center hatch open 1- CC Rider
- Media item
- Comments: 0
- Album: CC Rider V Berth Mods
-
-
-
-
-
20260602_182714.jpg
Starboard hatch open- CC Rider
- Media item
- Comments: 0
- Album: CC Rider V Berth Mods
-
-
Emergency Medical Insurance for Canada cruising
Thought I would chime in on the Canadian Coast Guard question while in PLI.... There is an RCMSAR (Royal Canadian Marine Search & Rescue) station located in Pender Harbor. Station #61. I believe that if there was an emergency medical incident in PLI and the JRCC (Joint Rescue Co-Ordination...- CC Rider
- Post #22
- Forum: General Chat
-
Upgrading AGM to LiFeP04 house batteries - Advice?
Hi Stephan; Thank you for the reply, while it would be nice to decrease the weight of the 2 FLA start batteries by using only a single one, I prefer to keep the 2 engine start batteries as separate systems. I power my downriggers and pot puller from the kicker's battery, and the kicker has...- CC Rider
- Post #5
- Forum: Electrical and Wiring
-
Upgrading AGM to LiFeP04 house batteries - Advice?
I am looking for advice and product recommendations for changing out my current AGM house battery bank to a LiFeP04 bank. Also thinking of adding a solar panel or 2 for the house bank in the near future. (200W or so..) I usually carry a Honda 1000i for charging the current system when on the...- CC Rider
- Thread
- Replies: 16
- Forum: Electrical and Wiring
-
Vberth Insulation
I used this stuff from US Energy (Amazon link): https://www.amazon.ca/dp/B00ZODN276?ref=ppx_yo2ov_dt_b_fed_asin_title I turned the foil side against the hull and glued it on with spray on contact cement, then used white duct tape to cover the seams. Turned out pretty good, and keeps the...- CC Rider
- Post #7
- Forum: Cabin, Interior