Recent content by Closecall

Thanks for the input, I've seen the bladder tanks and they are nice for extra fuel. Again I need to redo my anchors properly, and while I'm at it the old dirty tanks will be out and they need new sending units/wiring and fill/vent houses so I figure I'd go whole hog and install adequate fuel...

Because my boat is older with screws into the core. I'm thinking I want to check the core and redo the mounts for my fuel tanks. While I'm doing it I'd like larger tanks with no flakey gauges. I'm in Alaska were the OEM 23 gallon tanks will cost me several hundred dollars in shipping costs...

Spring is here in Alaska and my cdory 22 angler is getting a heater at last! Searched some threads and looked through the galleries and have a question on installation. I have the p6000 on hand but have limited mounting options due to the fact I have an Angler and the flue cap needs to clear...

Pulled the old engine and controls and just ordered the new df90a! That was painful. After inspecting the steering and realizing morse no longer supports the unit I have I think I'll go ahead and put in a baystar hydraulic unit. Doesn't make sense to have the new OB with 25 year old cables. I...

So I was thinking I'm going to call my Suzuki dealer tomorrow and get the ball rolling on a DF90a and then I found the following at the bottom of the performance tab for 22 anglers on the cdory homepage: 22 angler with 800 lbs of people, fuel and gear: Single 75 Honda: 2500 rpm = 8.5 mph 3000...

I did also talk to a fellow who has "our" hull style and a Yamaha 70. He said it works fine for his lightish angler, but he still almost wishes he'd got the 90. I didn't get a chance to get many details though. All in all, I'd like a new-design, proportionately light, Yamaha 90 :thup Hurry...

I've read red fox's reports but he doesn't give specific numbers. His boat is also very different from mine so I have to take the reports with a grain of salt. If I knew I could run 18-20 knots at less than 4000 rpms with say 800 or 900 pounds on board i'd go throw some cash at my local yami...

I researched the corrosion issues with the Suzuki and it seems to be a 2007 and earlier problem. You guys are confirming that for me. The new df90a seems to be the best 90 out there today I assume Yahmaha will update their 90 shortly...ala the new f70 and f115. Thanks for the feedback...

I've been lurking for quite a while, researching and this site has been a wealth of knowledge. After looking at almost every cdory in the state I just brought home an old garage kept 22 angler. It's got some dings and age on her but it's in great shape. The guy I bought it from (original...