Recent content by CPlay

Colby, Count me in. Thank you for organizing this again. (I enjoyed the trip last time despite my little mishap.) I'm not as adventurous as you when it comes to towing around the country, but this an easy destination for me. The Tennessee River is a great change of scenery from the Georgia...

Robert Youens with a co-captain this time and lots of support is well on his way. I hope they are having fun and I wish them all good weather and good luck. (My opinion is that this defeats the whole purpose of doing the loop, which is to enjoy the places along the way.) Garmin tracker...

Most engines have a flushing port either beside the cowl or under the cowl. Owners manual for engine should have this info. This would be a good alternative to using cuffs on the lower unit. You say you "can't quite" get motor clear of water. If I have a lot of fuel I have similar issue. I...

It was my understanding that all C-Dory 22 and 25 have always had balsa core. The Venture 23 and 26 have foam core and the Venture Sport 23 and 26 have balsa core. Someone please correct me if I am mistaken.

Great idea! I can't think of any downside. I would not add any rubber caps that could trap moisture. It's amazing what can be found on Amazon. It used to be that a machine shop would have been required for that type of part. -Jeff-

I also ordered one in May of this year. It is very nice quality. It was easy to order and pay. I highly recommend. It makes the boat look more classy. -Jeff-

Doing the Great Loop in a Jon boat when you can take your time and pick your weather days would be a reasonable rough adventure. Doing the Great Loop in a Jon boat trying to break a speed record is a bit insane. At least with a boat that small, he is only likely to be a danger to himself. My...

I started out with a thin indoor/outdoor carpet inside the cabin. It was inexpensive but offered very little padding and did not look very nice. I now have Luxury Woven Vinyl from Sailrite. It looks nice and feels softer underfoot than the carpet. Deckadence will be softer, but I prefer the...

I do not know if you trailer or keep your boat in the water. One thing not mentioned above is that if boat is kept in the water; Marine life growth on the bottom of the hull could cause performance to be that bad. If the hull is clean, then I agree with all of the above suggestions. -Jeff-

My caliper pins do not have the rubber cap enclosing the end. Maybe this cap is just trapping the heat. I would keep the slide pins well greased. Maybe cut a hole at least 2/3 the diameter of the caliper pin diameter, centered in the end of the cap? This might allow enough airflow to keep...

https://soundingsonline.com/features/de ... reat-loop/ Similar article in Soundings magazine with some different pictures. -Jeff-

Enjoyable article about doing the Great Loop in C-Dorys. https://powerandmotoryacht.com/voyaging ... -big-loop/ This article is also in this months Soundings magazine but I do not see it on the Soundings magazine website yet. -Jeff-

11 C-Dorys on Boat Trader at the moment. It is unusual to see so many on that site. The only downside to Boat Trader is sometimes the ads linger after the Boat is sold. (I found my boat on Boat Trader by the way. It was not listed on C-Brats site.) Historically, you have to be quick because...

Richard, I'm glad you found a solution. Dr. Bob's advice about a cradle is 100% the way to go. During a momentary lapse of judgement on my part this fall, I requested a forklift pick my boat up sideways. My logic at the time was that the port and starboard hull transom would be supported...

When I bought my boat it had two RH rotation 115 HP. I re-powered almost 3 years ago with two 90HP RH rotation. The starboard hull is much heavier than port hull on earlier Tomcat 24s. Your model should have water tank relocated to port hull to help offset this. I have felt the 2 RH...