Recent content by jbrosecity

I am pleased to report that just twisting the actuator body slightly tightened up the seal and there is no longer any evidence of a leak... thanks a lot to Tom!

ok I will try this later today when at the boat... will let you know how it goes

Hi Tom... the whole boat is a 2005. photo here: http://www.wind-seeker.com/temp/Bennett-trimtab.jpg I'll try your idea to tighten with a twist. I guess it just rotates on the lower rod with the actuator in place? Or do I need to remove the actuator first? thanks

Thanks for the recommendation to email Tabman... I have done so and hoping he can provide some clues joe

my right Actuator Assembly has developed a small leak when the tab is lowered or raised... it is coming out around the top cap. I realize I can buy a new one... my same model is available on Amazon. https://smile.amazon.com/Bennett-Trim-A ... B0006BJT00 But I was wondering if the Actuator...

We bought the little fella in central Florida last winter... a freshwater boat. We towed it up to Ontario and now to the Thousand Islands in upstate NY. Rather than tow him all the way back to Oregon, we have put him up for sale, available after Sept 20. You can see him and test drive him at...

Good morning and thanks to everyone for the helpful replies. I will try to address the various suggestions and posts in this single reply. First, let me be clear, we do NOT have the trim tabs down in these conditions. Matter of fact I haven't really figured those things out too well and...

I have a question about C-Dory 16 handling. I searched the forum using different keywords and the most relevant topic I found was this topic entitled 'Chines and tracking' from 2007: http://www.c-brats.com/viewtopic.php?t=6760 Obviously I am not the only C-Dory owner who has experienced the...