Recent content by Mike B

The manufacturers plate on my 22' Angler says 115hp is the limit. I have a 115 yamaha and its scary fast. I wouldn't go over 115. Pay attention to the weight of a new engine.

I might have been something I did at the beginning of last season, I may not have tightened it down enough. I realize now it came off too easy. Time to get a torque wrench. I didn't take a picture, Its always raised out of the water when at the dock and a lot of time when its not running and...

I'm winterizing my 2017 Yamaha 115 today and found that my propeller has a considerable amount of corrosion on the back that faces the engine. its an aluminum prop. Is there an anode I should be looking for. Everything else looks great, just the back of the prop that sits on that bearing. Thanks

I had to remove the portside fuel tank to work on the trim tab. the tank is in great shape but it looks like there is the remnants of some type of pad on the deck. Was there a pad or cushion placed there during construction and if so do I need to put something back down? What do I use. Thanks.

I had to remove the portside fuel tank to work on the trim tab. the tank is in great shape but it looks like there is the remnants of some type of pad on the deck. Was there a pad or cushion placed there during construction and if so do I need to put something back down? What do I use. Thanks.

Ive been diving from my 22' angler for 5+ years. 2 divers are fine, 3 on a calm day, 4 don't do it. you will be over weight and tripping over each other. You aren't going to like it and regret your choice.

https://youtu.be/y_MVYV2rC0A This is What I do on my 22' angler. My dive partner has the camera. He does a lot of videos, I'm always there when its in the water. I think this is the first time My boat could be identified as a C-Dory from the video.

I can find these type of bearings, I need the part number or correct dimensions.

as far as I can tell yes.

That's it . Little bearing, big headache.

Well now that its apart I found the problem with my windlass. The 2nd compound gear assembly was locked up. I freed it up and dissembled it and got a bearing rebuild kit from P2. The only part I cant find is a thrust pin roller bearing, it is the size of a 3/8 washer with rollers. Lewmar does...

IMG 0268

IMG 0270

Windlass gear