thataway's latest activity
-
Tthataway reacted to JamesTXSD's post in the thread 2006 Ez Loader single axel bunked trailer - $2,000. OBO with
Like.
Not with a GVWR of 4,600 pounds. A CD25 alone weighs more than that; the GVWR is the boat, trailer, and any stuff you have on the boat. -
Tthataway replied to the thread Tomcat outboard rotating props!.The idea of counter rotating props is for better handling in heaver cats. (the port engine turns clockwise (right-handed) and the...
-
Tthataway replied to the thread 2007 C-Dory 25' (Marsh Wren).Send a private message to DeNag or TyBoo--the administrators. Theyare listed under "members" several rows down as "Staff" send them a...
-
TThe 10 c-dory continues to prove itself as the ultimate date night harbor cruiser. Added EVA foam for comfort and non slip. Some cup/rod...
-
Tthataway replied to the thread How to get off the dock safely.Especialy with twins, I would consider putting a set of shifters in the cockpit on the aft cabin bulkhead. If you had an auto pilot...
-
TI would put a cleat along the dock a little forward of the helm side window. When departing I'd use a loose line looped around the cleat...
-
Tthataway replied to the thread Solar water heating project.I would consider the 12 volt DC / 200 watt heater to sustain a temperature already reached with 110V AC. I prefer the Bosch 2.5 gallon...
-
Tthataway replied to the thread Battery charger.Often problems are caused by the ground wire corrosion which seems to be neglected at times. Use your volt meter to verify that there...
-
TI have had similar things happen in the electrical system on boats I've owned from 12V to 120 VAC. I would suggest, disconnecting your...
-
Tthataway replied to the thread Replacing snap fastener.I like to put a little lube on the fasteners peroidically. There are some specific materials: Shurhold Snap-It Lubricant Stick or Star...
-
Tthataway replied to the thread Replacing snap fastener.I am having a little trouble envisioning which style of snap you are using. Normally the camper back use the "Dot" snap, with female...
-
TI ended up replacing all of my rivets with these SS barrel nuts from McMaster. It leaves a very clean finish inside of the cabin...
-
TI had a similar issue when trying to drill out my rivets. One option is having a helper inside holding the rivet with pliers, another...
-
Tthataway replied to the thread Repair/Replace Gunwale Wood.Good way to do the repair. I go a little further for the "seal" after the filling of the void. The nonskid is ground smooth (dremel...
-
Tthataway replied to the thread Garmin 2006c.I have used I phone and I pad basically since they were available, on the C Dory in that same area, and had no problems. IF we have...