In regards to winterization, if I empty the tank using the onboard water pump I'm left with about 1 inch of standing water in the tank which I wouldn't normally be concerned with, but the elbow for the pick up line is at or below the water line and could be subject to freezing/expansion so I used a 1/2 in polyethylene tube and ran it down the fresh water fill tube in order to reach the very bottom of the tank where I could then use a fluid transfer hand pump to extract significantly more water out of the tank, lowering the water level to a point the pickup elbow would be free of freezing damage. The PE tube I routed down the fill tube was a little tricky to get thru the fittings and then trial and error to get it to the bottom of the tank but I was able to do that within a handful of attempts. This effort, coupled with the bypass valve I installed close to the tank, allows me to run the pink stuff into the system and eliminates the need for me to put the pink stuff directly in the fresh water tank which would get diluted due to the inch or so of standing water in there.