Search results

They are all properly equipped with plastic for the shopping excursions. Who's got the platnum?

A few C-Brats decided they need more elaborate facilities and so leased this canal barge. Usually made it to the evenings destination to tie-up.

Trying to decide if we should shove off without the first mates.

Didn't see Humphrey or Lauren but sightings were rumored.

At first glance it looked like a cutout or decoy, the first of many.

Bird mini-bike Honda S-90 Honda CL-305 Scrambler Suzuli 250 X6 Hustler Kawasaki 500 Mach III Honda CL 350 Scrambler Honda CB 750 Norton 750 Commando Got married, no more bikes! But 1963 Corvette 327-350 4spd.

Widget had water coming in because several of the screws holding the brass stem guard on had penetrated the hull. With the boat on the trailer bow lower than stern you can wait to see if any drips form around the screws or backout the ones below the water line and watch the stream! I sealed them...

Highly recommend Oak Bay, Benjamin Islands and the abandoned harbor at Cockburn Island for over night anchorage/tie-ups.

I find no mention of the drum capacity of the EZ Pull for say 1/2" line. Does anybody have this info?

Where's her bow pulpit?

For those of us Downeast, www.maineharbors.com

Dave, Thanks for the offer of the shop manual, I have one and I find it's format lacking details. I was mainly concerned about the fittings on the ends of the cables. Looks like this will be a project for the end of the season with Widget in the backyard.

Any have advice/experience replacing the control cables? I put the motor in full up tilt forgetting the un-inflated raft was stored in the splashwell and put a perminent kink in the cables. I tried to straighten them and they do function but with way too much resistance. Is this a project best...

I would like 2 of these also. PM for details. Thanks!

Rick, Thanks for the very accurate cruise summary and your local knowledge during the cruise. Widget is longingly looking at the Fox Islands as the next adventure area. Dave

It doesn't take an engineer to know the all or nothing approach(solenoid) to a choke is not the way to keep the engine running when cold started. Mine (Honda 90) has always started but always been difficult to keep it running until 3 or 4 starts gets it warm enough to continue running. Poor...

I'm using AT&T air card mainly because of better coverage on the coast of Maine. The speed varies from true broadband speed to dsl but is always better than dial-up. Been satisfied with it in this area. 2 year contract $49/month unlimited time.

No description

My "plastic" fitting leaked around the mounting flange and through the mounting screws that penetrated the bulkhead wall. Took several tries to figure out it wasn't just a loose plug.