Search results

Well, I'll give the vivid a shot then. This stuff as almost as expensive as printer ink.

No idea about what the previous bottom paint is. It's showing through in many areas due to bunk rub and general wear. I'm not too worried about VOCs as a i have a full face respirator with organic vapor cartridges. This boat doesn't really need any bottom paint as it's only in the water for a...

So i just had a booboo below the waterline. It's all better now and i'll talk about it on another thread....lets just say that my bilge pump auto on feature works great. Anyways... I'm not at a point that i need to put on bottom paint. The boat came with bottom paint but i'm not sure what...

I have two camping chairs i bought at costco and put cane tips on the legs. they work great. cheap and low stowage factor.

So i've never had my wildcats slip, i've never had the chain skip. This is in all kind so rough conditions. I'm all about redundancy but has anyone ever had their gear pay out accidentally?

Same exact thing!

So i've just removed my sewage ovbd pump...again. This is the third Jabsco 18590. Maybe i should try a new pump? something that lasts a bit longer. Recommendations?

Hi Bob, well, that pump made it all the way up till now. I'm mighty tired of these jabsco 18whatevers. What do you recommend i upgrade too?

Hi Bob, Turns out the senders were fine. the positive cable going to the stbd sender had slack in it and worked it's way under the fuel tank! Well it eventually chaffed through. God help me if I ever have to pull that stbd sending unit, the access is muy terrible.

I stuck a tape measurer down hole after removing what's left of the port sending unit. about 10.5" but i think to error on the side of safety I should install a 10". I just ordered some of oem ones last night but i may return them. The Stbd side looks like a real bear to get at, port is a dream

Well Bob, in my troubleshooting the fuel arm fell off into the tank on the tank that was working...i think i'm going to buy two new fuel sending units. Got any part numbers?

Bob Austin 2024

I cleaned up both terminals with not resolution of issue. Given the spacing i'd have to rig up some jumpers to get from one side to the other but it is doable. I feel i should also check the voltage at the gauge. I'll post my findings. -Thanks, Conrad

Hi Bob, I'm having some issues with my stbd fuel gauging system. Both port and stbd sensors have exactly 7 volts going to them (kinda seems low?). No issues with the port; currently the tank is full reading 30 ohms across the sensor. Stbd tank is also full, reading 40 ohms across the sensor...

...I want your problems.

if you're in CA i'll take you for a spin.

Don't blame you. lots of competition in that space.

What is with the big engine small engine!? gross!

there are a few in SB harbor. They look nice. Really a different animal than a tomcat; one can fit on a trailer barely, the other is in big rig territory.