Search results

  1. P

    Trailer Tires

    A good question to have answered on this forum would be, What is your typical cross country cruise speed when you are towing? Mine is 60 mph when towing my bigger boats. In 35 years of towing bigger boats I've never had a blow out. I do watch the age stamp on the tires when I buy them and...
  2. P

    Suzuki DF140 Oil Change - Quick Question

    I do my outboards cold. The viscosity issue is there, but you just have to wait a while longer. And yes, the oil does pool up more in the crankcase after the engine is shut down and you do get more out. At least that is what my own experience has been. I'm pretty sure that the general wisdom...
  3. P

    14th Annual Delta/Bay Extravaganza, April 6 to 10, 2016

    Snowing outside, about an inch on the deck. I can't bear to look a the pix, but I did. Made me crazy. Beautiful boats on a beautiful trip. Yuck!
  4. P

    Trailer Use Questions

    Oh, I failed to vote enthusiastically for the guide posts when loading the boat. I simply can't get these larger boats onto a trailer without the posts. I'm that bad at boat handling I guess. They are particularly necessary for me when loading in the wind and with only my 5 foot tall spouse...
  5. P

    Trailer Use Questions

    I've seen boats that have come off trailers for one of two reasons. A. Failure to adequately secure the aft end of the boat to the trailer frame. (wind gust causes abrupt fishtailing and the stern flips off the trailer and all hell breaks loose). B. Panic stopping causes the boat to climb up...
  6. P

    Help Please, No Power is Reaching Electrical Panel at Helm!

    There is a mechanical reason for not soldering the terminals after crimping. A good terminal and a good crimper will create a junction that minimizes cold working of the wire material. This lesson was learned the hard way in aviation because of vibration. Solder can create a situation that...
  7. P

    Help Please, No Power is Reaching Electrical Panel at Helm!

    There is a mechanical reason for not soldering the terminals after crimping. A good terminal and a good crimper will create a junction that minimizes cold working of the wire material. This lesson was learned the hard way in aviation because of vibration. Solder can create a situation that...
  8. P

    Hi New Member with some ?s

    Nope, not even for the 25 and for sure not the 26. Now, if you are only going a few miles from storage to the ramp, then you would be fine. If you are going to climb any mountains and go many miles, you would be "under-trucked." I know there are people on this board who will take some issue...
  9. P

    Debris Flow Video, Utah

    It really is pretty on topic considering the many different uses that C-Dory boats are put too. Lake Powell can be very dangerous even with sunny skies when there are storms within 50 to 100 miles from the lake. There are numerous harrowing posts by people who've been anchored on the beach...
  10. P

    Compression test results??

    Compression tests are never about compression being too high. It can be about being too low. However it is about making sure that all cylinders are operating the same relative to each other. By the same, I mean withing 15% or so of each other. One cylinder being higher by even more is not...
  11. P

    A CD22 Cruiser found almost in hailing distance from my home

    Anything much above 20 grand for the boat as you've described it would probably turn me off. So much can be wrong on a boat that has been sitting out in the weather, unused and uncared for. But, at 20 grand or thereabouts, you can afford to take a chance. 40 grand would get you a newer...
  12. P

    Celebrating 3 years of living aboard

    Definitely, don't miss the West with its wonderful systems of lakes and the northwest oceans. Lake Powell should be on your bucket list along with the cour d elane and pondere (I know, I'm too lazy to look up the spelling. They are the two huge north Idaho lakes). Also the snake and Columbia...
  13. P

    honda 135 on 22 cruiser?

    I think I read all of these posts pretty carefully, but I didn't see the most important point made. The transoms on the 22 are well built, but there is a cantilever force put on the transom that is very high when you go WOT to get on plane. I'm pretty sure that the engine weight was only one...
  14. P

    Single axle trailer OK for a 22' Cruiser? More questions

    A 3600 mile round trip for a questionable boat with a single axle trailer is not something I'd consider unless the owner is going to have the motor fully serviced and inspected and with some warranty. I'd consider this boat a project at best and 12 grand without a running motor would be a fair...
  15. P

    Best very small dinghy motor

    suzuki 2.5 is terrific.
  16. P

    2016 Chesapeake Bay Pocket Yacht Rendezvous (CBPYR)

    I would love to bring Poopsy, our new to us Ranger Tug R21 Classic, to such an event. But, that is a really long tow. Maybe we will be able to do a piece of the Erie Canal next year that would tie into your event. Now, that would be fun.
  17. P

    Repowering of 22 foot C-Dory

    Double ditto's on the twin 50 hp Suzuki option. Also almost equal ditto's on the E-tech option. The days of Honda and Yamaha dominance are over as there are so many excellent options...not to disparage Honda or Yami as they are good too. But my experience base is with E-tech and Suzi.
  18. P

    Towing a 25' with what?

    I bought my 2006 dodge 2500 diesel for 25,000 with 50 thousand miles on it. That was the book price then. I was shocked to find out that the book price on the truck with 125,000 miles on it now and 7 years later it is booked at 24,500 dollars. Check out the Ford and Chevy depreciation...
  19. P

    half way done fixing up 1981 classic

    Very very nice. When you began were there any core issues with that boat? What was its history in terms of being slipped and stored out doors. I've been looking at some older C-Dory's to replace my 2006 that just sold. But there has been concern expressed on the Brats site about core...
Back
Top