Search results

In the splash well, secured to a padeye, Also feeds the kicker.

Fans: Caframo 747

How many Amps does it draw? I don't think you'll be able to run it very long unless you have a generator.

Engel is having a Summer sale on their MR040F-U1 ac/dc fridge $150 off plus free extended warranty. Limited time. I got one. https://www.engelcoolers.com/shop/12-vo ... 9UQAvD_BwE

I got the 13" yesterday, blades look a little flatter than the 15", we'll see what happens when back in the water. Thanks

The boat is mostly heavily loaded, aluminum prop, 0n a good day I'll get to 5k @ WOT playing around with tabs and motor trim. I usually reach high teens in knots then. This is all at sea level when sea conditions allow, hard to find a day with really flat water though, I am sure That makes a...

What prop size and pitch are you using when in full cruising mode (heavily loaded that is) and at sea level? What max rpm do you achieve with that prop? my 15 1/4 x 15 is not to snuff I am thinking of trying a 15.5 x 13.

I have 150 ft of chain with plenty of nylon behind on a 9 kg Vulcan, great set up for the windlass, so far no cons

Ron & Micah Ron, my holding tank is under the toilet bowl in the head, the water tank, under the splash well, as measured (10x30x20 approx.) is too big to remove even with an extra vertical hatch on the forward part of the well. I am hesitant to cut too many large holes in that area as I feel...

We are in Puerto Escondido right now on our 25. We left San carlos (Sonora) in March , slowly made our way down to La Paz and are now on our way back up to San carlos. I must say that I felt the same way you do about the water tank capacity on the C-Dory before our first trip down the Sea a...

Bob, to first try the inspection hole size before cutting the whole top off is now the new plan. I will have to wait until i am home though.

Progress report (or lack of it) Food coloring was added to empty tank along with a couple gallons of water: red water started slowly seeping in the bilge within a minute.. One last brain storm, it is obviously a small crack according to the rate of leaking, it is on the bottom of the tank or...

Bob, beads of cold sweat were forming on my forehead as I was reading your last post, I wish I had the confidence and abilities to undertake such a project but i really don't. In the event I am unable to locate that leak, I was thinking of just cutting out the very top of the tank itself and end...

I can only visually check the two sides and top, I would have to remove the tank (impossible without doing destructive stuff to the splash well) to see the front, back and bottom. The connection to the pump has been checked and triple checked since it was the first suspect and is consistently...

I have a 2011 25 cruiser with the water tank under the center of the splash well, it seems to have developed a leak, not a big one, maybe a pint a day or so. At first I suspected the lower hose connection (pump feed) but that's clearly not the source. The two others fittings (fill and vent) are...

I have the Lenco trim tabs and used the Garelick bracket on the Starboard side for my 9.8 Tohatsu, works great.

With 3 strand nylon line a tapered splice is not too hard, lots of info online, even step by step videos. If you mess up the first one or two you still have plenty of line left to keep on practicing,.

Avidmagnum was a big, big help with advice and measurements for setting up my new LoadRite, thanks again Tom!

About 30x30 at floor level, depth varies somewhat as you go up due to hull shape and built in chases.

Did you fill the new filter with gas before installing? Are you holding the bulb vertical while squeezing?