Search results

Can anyone direct me to a thread or provide advice on de-instlalling and installing control cables on a CD22? I have a 2003 with twin Yamaha 50 4 strokes. I can disconnect the old cables at the motor without a problem, but not sure at the helm where the cables are routed through the cabinetry...

First salmon in two years in N CA. Bodega - Pt Reyes. 4/2 - fished with a partner in rough conditions 10 - 20 mph 4 - 6 seas approximately 5 miles out of Bodega. Hooked 2 and landed one 10lb king 45' with a watermelon apex. 4/7 fished with same partner for two kings, 13 & 18 lbs, one 40' &...

Can anyone recommend a good solvent to remove bottom paint. I believe the bottom paint type I have is the non ablative finish. Rather than sanding or grinding, I am hoping there is an easier way to remove without damaging the gelcoat. Any comments or recommedations would be appreciated...

Decided to make another tuna run to Half Moon Bay again as the weather and warm water moved within range again (42 miles). Launched from Pillar Point Harbor at 4AM and motored out to our numbers in 2 - 3 ft seas with 5' - 15" mph winds. Ran 15 mph for the first 1.5 hrs in the dark, then a...

Three of us fished out of Half Moon Bay on the maiden tuna run for my CD22 this past Saturday. We trailered down to Pillar Pt Harbor the day before and got a slip for 2 days...a great way to avoid launch traffic and test out the cabin accomodations. At 4AM, we motored out 38 miles on flat...

I should have started a new thread instead of adding to a different topic altogether...so here goes. I have tried searching in our library, but have not found if twin 50's (what I have) or 40's require two separate fuel filter/separators or just one adequately sized one? I have a Racor...

Hello All Twin Honda 50 Owners: I know there are a lot of you out there and since there are so few twin 50 Yamaha owners (which I am one), I need some advice. On my CD 22, I am running 14" pitch SS props, but when I test ran the motors, I found I could only get 4700 RPM's which my mechanic...

Hello, I am somewhat new to this forum and have twin 2003 carb 50 4 stroke Yami's with 14" ss props on a CD22. I took my boat for a test run last week for the first time and saw that my max rpm was 4700 rpm, somewhat below the recommended 5000 - 6000 rpm. I have the normal load of fuel (50...