Search results

The driveway test is a good idea. You could try starting the motor at 10 volts. Some Chart plotters and GPS have low voltage alarms that may help monitor what is going on. I can appreciate your feelings about keeping it simple but I suffer from battery discharge anxiety. The only solution for me...

Feb 2015 Projects

Before stripping

Added a small fuse panel to accommodate the LEDs

IMG 20150130 215051077

IMG 20150130 215025288

IMG 20150130 214857889

I installed White and Red strip LEDs and switched them seperatly

IMG 20150130 214830821

Red LEDs in side pockets light up the cockpit

Sling using the above ground lift

Rubbed out the sanding scratches using 3M polishing compound then a detail polish.

It takes two coats with a dwell time of 10 hours

Smart Strip is safe for the Gelcoat

Stripping bottom paint Smart Strip is Gelcoat safe

Brow handles

Brow handles

I have a Suzuki 115hp. Replacing the water pump impeller is pretty easy. I ordered a complete water pump kit that included the housing, keyway, gasket and impeller. I also ordered a spare prop nut and stainless cotter pin. As it was i only needed the rubber impeller. I carry the used impeller...

If you have a schematic you could rig a jumper to put power to the lift side of the hydraulic motor. Be sure you know which is the negative and positive.