Latest activity

  • C
    C-Hawk left a message on Ddawg63's profile.
    I'd like to see pics of your 16'. Where are you located? Thanks Roger
  • D
    drbridge posted the thread Member Location in General Chat.
    One thing that I miss about the old site is the General Location of the members that used to be listed but are no longer there. Is this...
  • D
    drbridge replied to the thread Cockpit Step.
    The steps are 15" wide. top is 5" deep and Bottom is 8" deep. They are spaced 12" apart. The bottom step does not rest on the molded...
  • S
    ssobol replied to the thread Refrigerator.
    My boat came with a Norcold AC/DC refrigerator. Runs off the battery when shore power is not available. Draws about 3 amps at 12V when...
  • J
    JCPettit replied to the thread Trolling with twin motors?.
    I have no issues doing 3 knots and that’s slow enough for Stripers on the Bay. If I need slower, I toss a sock.
  • D
    Dora~Jean replied to the thread Trolling with twin motors?.
    Has anyone tried raising the motor a bit?But not too high as to reduce the cooling water flow through the engine?
  • R
    RDiemidio posted the thread Refrigerator in General Chat.
    What brand refrigerator. Ac/dc unit or just dc? I would like to install under rear port side seat seat. I have a 23 Venture.
  • Ken O
    Ken O replied to the thread Unity gain antenna?.
    Thanks Bob! I should clarify: I am willing to put the antenna on the roof, probably on my roof rack, but I am hoping to get away with a...
  • D
    DayBreak replied to the thread Foam core vs. Balsa.
    CPlay you are correct. Also, just this last May, Michael Millison from the factory at NMI told me that all new C-Dory models would soon...
  • T
    thataway replied to the thread Unity gain antenna?.
    The antenna you cited will be unity. There are a number of antennas which are 3 db gain. There are Marine VHF 36" (1/2 wave) base...
  • T
    Tom Hruby replied to the thread Cockpit Step.
    With regards to the step stool: The edges are rounded and I have added corner bumpers (for tables) that are not shown in the photo. We...
  • S
    Schuster replied to the thread Cockpit Step.
    Very nice workmanship and practical design. How thick is the plywood? Did you use two sheets on the bottom step? Are those dowl pins...
  • J
    JamesTXSD reacted to drbridge's post in the thread Cockpit Step with Like Like.
    These are the steps that I made for our 22 cruiser.We have been using them for around eight years and we use the boat a lot. They make...
  • S
    Schuster reacted to drbridge's post in the thread Cockpit Step with Like Like.
    These are the steps that I made for our 22 cruiser.We have been using them for around eight years and we use the boat a lot. They make...
  • D
    drbridge replied to the thread Cockpit Step.
    These are the steps that I made for our 22 cruiser.We have been using them for around eight years and we use the boat a lot. They make...
    • PXL_20230610_205716273.jpg
    • PXL_20230610_205811218.jpg
Back
Top