Latest activity
-
SSchuster replied to the thread Member Location.Yes, interesting that this topic just came up, as I was just trying to find the location of a member and had no luck. One used to be...
-
Thanks everyone. Sounds like it would be hard not to go this route. Very interesting about carrying good signal through the roof. We... -
FFoggy replied to the thread Charging Dual Batteries.My understanding: If the 2 batteries are identical except for a (small ?) voltage difference and are connected properly in parallel, the...
-
Ppcg replied to the thread Re-ordering images in an album..I'm hoping there is a way to reorder, but in the meantime I deleted the contents of the album and re-uploaded the images in reverse...
-
Ppcg posted a comment on the media item transom 1.JPG.Here's what my transom looked lke after removing swim step, motor, and transducers. Existing holes were drilled out, any bad balsa core...
-
Ppcg posted a comment on the media item transom 2.JPG.My boat originally had a black plastic cap over the top of the transom. Part of it was missing and it was evident someone had done...
-
Ppcg posted a comment on the media item transom 4.JPEG.What a mess! How far does this go?
-
Ppcg posted a comment on the media item transom 3.JPEG.I grabbed a chisel and went to work. I found that someone had covered up rotted balsa (or maybe it was just wet at the time?) with some...
-
Ppcg posted a comment on the media item transom 5.JPEG.What I found was dry rotted balsa.
-
Ppcg posted a comment on the media item transom 6.JPEG.Eventually I got to balsa that was hard and solid.
-
Ppcg posted a comment on the media item transom 7.JPEG.In a couple places I had to dig deep to get to good balsa.
-
Ppcg posted a comment on the media item transom 8.JPEG.Here I've replaced the rotten balsa with new balsa. It was bedded into epoxy and I've set up a jig so I can use a router to make the top...
-
Ppcg posted a comment on the media item transom 9.JPEG.Once the top of the new balsa was leveled, I placed some thickened epoxy on the top and let it cure.
-
Ppcg posted a comment on the media item transom 10.JPEG.Here I am positioning a jig to assist in leveling the top of the transom before adding the fiberglass cap.
