Latest activity

What's new Featured content New posts New media New media comments New resources New profile posts Latest activity
  • P
    pcg posted a comment on the media item Hightop 11.
    Done. Well, except for sanding and fairing. The new sections consist of two layers of 1708 with additional layers at the edges and...
  • P
    pcg posted a comment on the media item Hightop 10.
    Masonite forms in place for laying up the corner gaps.
  • P
    pcg posted a comment on the media item Hightop 9.
    Front section has been laid up.
  • P
    pcg posted a comment on the media item Hightop 8.
    Front section has been laid up.
  • P
    pcg posted a comment on the media item Hightop 7.
    I used 1/8" smooth masonite to make a curved form to close the front of the roof.
  • P
    pcg posted a comment on the media item Hightop 6.
    I built a wooden cradle to hold the roof off my work table so I could work on it without distorting its shape.
  • P
    pcg posted a comment on the media item Hightop 5.
    Once the walls had been extended I reinstalled the roof top.
  • P
    pcg posted a comment on the media item Hightop 3.
    Once in my shop I cut the top of the roof off.
  • P
    pcg posted a comment on the media item Hightop 2.
    Done! Scary that this only took two minutes! Not enough time to change my mind...
  • P
    pcg posted a comment on the media item Hightop 1.
    I decided the best course of action for converting to a high top was to remove the roof and then do the modifications in my heated shop...
  • P
    pcg posted a comment on the media item Hightop 4.
    I used smooth 1/4" masonite to make forms (forgot to take pictures) for the new sidewalls and applied one intial layer of 1708 fiberglass.
  • S
    Schuster replied to the thread Member Location.
    Yes, interesting that this topic just came up, as I was just trying to find the location of a member and had no luck. One used to be...
  • jkidd
    jkidd reacted to Ken O's post in the thread Starlink Internet? with Like Like.
    Thanks everyone. Sounds like it would be hard not to go this route. Very interesting about carrying good signal through the roof. We...
  • F
    Foggy replied to the thread Charging Dual Batteries.
    My understanding: If the 2 batteries are identical except for a (small ?) voltage difference and are connected properly in parallel, the...
  • P
    pcg replied to the thread Re-ordering images in an album..
    I'm hoping there is a way to reorder, but in the meantime I deleted the contents of the album and re-uploaded the images in reverse...
Show older items
Back
Top