Recent content by imabrat2

My concern was the same as C-Otter. I think I am going to buy a couple plugs to have available for the drain holes (they are higher than the scuppers of course) but I was mainly concerned about the flapper valves to the pump in the bilge. I need to look into that alarm. As always lots of good...

First of all, THANK YOU for the many replies. I have only a single engine. However I read somewhere that a full tank can change the trim of a 24ft boat from 2-4". It also appears that under 4" from the waterline is not desirable for any thru hull. I think I will maintain a reduced tank weight as...

Have a C-Dory '08 25ft cruiser and noticed the bilge pump drain outlets (scuppers) at the stern are either at or slightly below the water line when at rest. I'm guessing this was a design ?flaw and not the extra weight of a 3rd battery in the compartment. Wondered if anyone else has dealt with...

Thanks for the quick and encouraging response. It is fortunate to have access to a site such as this with such a wealth of information and experience. Because the boat needed all those minor repairs, bottom painting, and required decals/equipment, I haven't had it out yet. One problem (I need to...

Recently purchased a 2008 C-Dory 25 cruiser located in Saluda Virginia. Like to find someone nearby familiar with this boat who might go out for a couple of hours with me or their boat to "show me the ropes".