Recent content by jrassier

This aluminum $120 prop (Turning Point Hustler 4 Blade 13.5x 15) delivers 24Kts /6200 RPM at WOT on our 22 Cruiser/BF90 lightly loaded. And 15Kts/ 4.500 RPM 4 blade props have better reverse thrust, more lift/better hole shot than 3 blade screws, generally a 3 blade will have a bit more...

I have used the Shunt Bob mentions for one season (AiLi-Voltmeter-Ammeter) So far it has preformed well monitoring SOC on a single 100Ah LiFePo4 battery It is accurate to .01 V compared with readings taken with a Fluke 87 multi meter.

First splash for Sandy Bottom

Hitched up and headed home with our 2nd CD

Have used two pair of Alpen apex 8x42's for 8 years primarily used for birding, but work well aboard. Bright & sharp glass. No issues with either pair do date. Primary boat glass is Steiner 7x50, 10+ years and still doing a great job. Picked up a pair of Nikon action extreme ATB 10x50's...

IMG 20200803 124545912

New home at the fish camp on Dauphin Island

Little Dauphin Island

Dauphin Island bridge at little Pass Margaret

https://www.c-dory.com/series/19/

Anyone have this part number? Thanks in advance.

I have drilled a 1/8" hole through the side of the Racor filter about 1/16" above the edge of the metal base. (just above the fuel bowl) Push a small cotter key into the hole . The pin prevents the inner plastic ring from spinning inside the metal housing of the filter

We have a Honda BF90D on our 19 Angler. At sea level, with 3 on board, light gear and topped up on fuel running a 15" prop WOT is 34mph. I have often thought that a 75 would be an even better match for our purposes. Ran the boat for the first season without a Permatrim. Installing one definitely...

It's 39 inches . Eye balling it with a tape over the camber of the pilot house,holding a flashlight