Recent content by maryswensen

Is anyone familiar with boating on the Susquehanna south of Wilkes Barre PA?

This might be of help. I was advised to spray WD40 down the outlet. Worked like a charm. I was advised that salt can block the channel and WD40 clears it out. Good luck Ed

Peter and all: Thanks for your advice. We are about to start the installation. The placement of the pump still is not totally resolved. If we install it on the bulkhead in the berth area the hoses do take up space for sleeping. If we install it on the bulkhead in the cabin it seems to fit...

I am about to attempt the installation of a S1000 auto pilot, and am hoping that someone has already had the experience. My major concern rests in the best placement for the pump. Any advice will be appreciated! Ed

C.W. I got the impression that the changes would be minor. Lights sound easy and it comes with an anchor set up. Ed

Jay Thanks for taking the time to respond. With the information provided, I believe the Mokai would be a winner for our needs. I contacted Marie at Mokai - very pleasant and informative. My daughters and I will be taking a drive to the factory in Newburg, NY this Friday. She informed me that...

After reviewing, for about the fifth time, the great pictures of the Hunkydory adventure I continue to be facinated by the Mokai. I am about ready to sacrifice my daughters' meal plans and purchase one. Before I put these young women on diets I would appreciate any feedback on use. Towing...

Mike and Joe Thanks for the advice. My only concern is the cut out of the dinette seat. After managing to puncture the port fuel tank while installing the tabs, I have a healthy respect for what might happen. I cut the blade of the saber saw to a length that on the down stroke it will not hit...

Joe, Thanks for the advice. Yes I believe that would put the boat rather off balance. It might give me an excuse, however, to overindulge all in the interest of safety. I believe I will retreat to a between the fuel tanks position. It appears that the water tank compartment is a "molded in...

For some time I keep returning to Mike's (Shelly IV) post and pictures on his set up for the charger, ac panel and all that goes with it. The water tank area seems to provide an answer for many of my questions regarding placement and space. We, however, have a 2007 model of the C-22 and the...

Caty: I have had one of these units for two years. I use it for dock inspections and lost treasures. You can adjust the angle of attack by sliding the weight. Hope it helps. Ed

Warren and Joe: Thanks for the information. I am going to opt for Warren's Plan B. It seems to be the most direct and perhaps most economical. When it comes to boating the line between needs and wants does appear to get blurred. Thanks for your help! Ed

Some time ago I came across a C-Brat that developed a davit system to hoist a dinghy to the cabin top. Does anyone recall where I might rediscover this posting? This site is almost as much fun as boating! Thanks for your help. Ed

The model of the chartplotter is RC435. Thanks

I am attempting to interface the S1 to the chart plotter. The S1 has a rectangle data cable while the chart plotter has a circle pin connector. There rests the problem. The color of the wires do not appear to match. I am wondering should I mate the ins and outs and forget colors? Again Thanks