Mike R wrote:
Mike, until you try a boat with and without trim tabs and the Permatrim you won't see or know the advantage. My first 22 had neither. My neighbor had a light 22, and he first added tabs--I thought what the heck--my boat runs fine. I rode in his boat--and it was better, especially going into chop. Then he added the Permatrim--again--"he is out of his gourd"--Then I rode with him again....FF to my 25--came with trim tabs, and good--then I added the Permatrim--better.
The boats will do fine with out the tabs and Permatrim--they will just run better with both. Just my opinion.
I agree with trying and balancing the boat as best as possible with movable items to achieve as close to "ideal" as possible. But then there are always spoilers. My first ride in my son's Cruise Ship 25 ( door and aisle offset to Starboard) out in the chop--his wife and daughter were in the aisle, plus he is in the 240# category at the helm-- I am scooting out as far outboard as I can in the forward dinette seat to try and balance the boat--no one else seems to notice we are leaning about 10 degrees to starboard even on a plane. It seems a lot of folks are not sensitive to the feeling of the boat listing or of the balance of the boat. (The boat handled far better once we got everyone "centered".)
Mark--my current 22 still has the plastic" Doel fin"" the boat came with--I think the Permatrim is better, but it was out of stock when I was first "re outfitting" the boat--and I just never changed it...
Bob Wilkinson I got a laugh out of the Seakeeper! The Seakeeper 3 is due out in 2017 spring. (Boats 30 to 39 feet) 550 lbs :26.8 L x 27.0 W x 22.5 H (inches) and requires 1000 watts, but treated at 85 amps 12 volts. (Should be installed in the aft part of the boat, in the centerline)...cost only $26,900, plus installation. Granted they are really impressive gyroscopes! However, it dampens roll, but I believe the trim tabs would still be desirable for both lateral trim and fore and aft trim in many conditions...
If interested in stabilizers this link is a comprehensive read. Video foundhere
There is more damping in roll than in pitch (because that is the way the gyro is designed). The amount of roll is decreased by 50% (from 12* to 6*. But there is still some roll, less snappy however.
Personally I've not yet encountered a need or desire for trim tabs on my 22', not for side-to-side trimming, running with a cross wind, nor for slow planing or keeping the bow down. BUT, the boat is still very new so perhaps someday I will, but I remain a skeptic for now.
Mike, until you try a boat with and without trim tabs and the Permatrim you won't see or know the advantage. My first 22 had neither. My neighbor had a light 22, and he first added tabs--I thought what the heck--my boat runs fine. I rode in his boat--and it was better, especially going into chop. Then he added the Permatrim--again--"he is out of his gourd"--Then I rode with him again....FF to my 25--came with trim tabs, and good--then I added the Permatrim--better.
The boats will do fine with out the tabs and Permatrim--they will just run better with both. Just my opinion.
I agree with trying and balancing the boat as best as possible with movable items to achieve as close to "ideal" as possible. But then there are always spoilers. My first ride in my son's Cruise Ship 25 ( door and aisle offset to Starboard) out in the chop--his wife and daughter were in the aisle, plus he is in the 240# category at the helm-- I am scooting out as far outboard as I can in the forward dinette seat to try and balance the boat--no one else seems to notice we are leaning about 10 degrees to starboard even on a plane. It seems a lot of folks are not sensitive to the feeling of the boat listing or of the balance of the boat. (The boat handled far better once we got everyone "centered".)
Mark--my current 22 still has the plastic" Doel fin"" the boat came with--I think the Permatrim is better, but it was out of stock when I was first "re outfitting" the boat--and I just never changed it...
Bob Wilkinson I got a laugh out of the Seakeeper! The Seakeeper 3 is due out in 2017 spring. (Boats 30 to 39 feet) 550 lbs :26.8 L x 27.0 W x 22.5 H (inches) and requires 1000 watts, but treated at 85 amps 12 volts. (Should be installed in the aft part of the boat, in the centerline)...cost only $26,900, plus installation. Granted they are really impressive gyroscopes! However, it dampens roll, but I believe the trim tabs would still be desirable for both lateral trim and fore and aft trim in many conditions...
If interested in stabilizers this link is a comprehensive read. Video foundhere
There is more damping in roll than in pitch (because that is the way the gyro is designed). The amount of roll is decreased by 50% (from 12* to 6*. But there is still some roll, less snappy however.