just purchased 2004 22 cruizer.

C

cbull

New member
Thanks for all the help. I have to get to work on the new rig. The boat was built with bench seats rather than table, sink, ect. Will be putting a/c on boat this week. I will take photo's for post. I am going to take all the wood from inside the cabin and use honey comb fiberglass lam. should take a lot of weight out of cabin. Have only noticed a couple of bad spots on the boat. One being on the floor at corner of front bilge area and the other in cabin wall where screws are covered with fiberclass.
 
I am not ready for the water yet. Need to do some sea trials just to make sure she will run good. I purchsed the boat from a local dealer. the boat was on consignment and dealer had little knowledge of history. engine only has 100 hrs on it so it should be fine. However, 30 gal. of gas had to be drained because it was bad. I may have to take the carbs of and clean.
 
Been there...done that...LOL! Just had the carbs rebuilt on my starboard Honda 45....it now runs so smooth that the port engine idles rough by comparison.
If you decide to come up...there will be a choice of about 17 C Dory(s) to tow you in if need be. :lol:
 
Back
Top