(Sold) 2003 22 Cruiser, $35,000 (Vancouver, WA)

M

MC Mannell

New member
Selling my 22 Cruiser. It has the Diesel Heater, elec.STB wiper, cabinet instead of fridge, dry decking, twin Honda 40s, and a single axle galv. trailer....no electonics.

Vessel has very low hours and is in very good shape. Burgundy in color....
 
Blain,

All you have to do is click on the E-Mail envelope provided and make a simple request. That's what every one else has been doing. Unless of course you're missing your trigger finger. If so, try using your thumb. :wink

Mike
 
that's good, It should help ease the pain......I hope it doesn't get stolen.......yer going tractor shopping tomorrow I bet
 
I am going to wait until next spring for the saw mill and tractor. I'll be heading over to my farm in October to do some slash burning and timber management work. It's gets pretty cold over there at this time of the year at night. I can't get a permit to burn until it rains a little. I don't want to have to pay the bill for catching the Strawberry Wilderness on Fire.... :smileo
 
yup, cold indeed but that sure is some pretty country...but cold.
Have you check out those Wood Mizer mills in Portland on Columbia Blvd? Gots an in-law that has one and just loves it, says that he gets a lot more useable lumber out of it than his old mill.

Do check back and keep us updated
 
B~C":3gle1lq8 said:
Have you check out those Wood Mizer mills in Portland on Columbia Blvd? Gots an in-law that has one and just loves it, says that he gets a lot more useable lumber out of it than his old mill.
Click to expand...
If you get the Wood Mizer mill, make sure you get the diesel engine on it. Don't get the gas engine, they don't have the lugging power and you will end up with wavy lumber, especially if it has knots. I have one (have had it for over 10 yrs) cut lots of lumber with it.
 
Dave,

Really? That's great to know! Can you get the diesel on the personal sawmill? Or...to you have to go big? I'll check that out for sure. I 've got a lot of pondarosa pine on my place....

Thanks...

Mike
 
Mike - right after I got ours 10 to 12 years ago, they came out with a diesel. As far as I know, it was going to be available on all their band saw mills.

We just moved ours over to the Dalles Mountain Ranch, just across the river from The Dalles, Oregon. Don’t have it set up yet but will be cutting Pine, Doug Fir and Oak, once it is set up and one of the ranch hands has been trained to use it.
 
Back
Top